OPV P03 Shield

Buoyancy Systems · Overpressure Relief Valves

OPV P03 Shield

Combines patented Core-Sink Technology and Shield Technology within an ultra-flat relief architecture, pairing passive debris protection with 450 L/min exhaust capacity and native compatibility across the P03 Series flange family.
Lid Design:
Relief setting (Cracking Pressure):

CONFIGURATION

Pull knob
Type-C

Nominal opening pressure
≈ 0.18 bar (2.61 psi)

Be notified when this product becomes available.

 Join the waitlist
OPV P03 Shield in side profile, peaked tented lid linked by a corrugated hose to the connector
  • OPV P03 Shield in side profile, peaked tented lid linked by a corrugated hose to the connector
  • OPV P03 Shield front view of the domed lid face with hose routed to the connector
  • Exploded view of the P03 Shield valve: lid, coil spring, seat and diaphragm in sequence
  • P03 Shield valve close-up on a quilted fabric panel, Powered by HYDPRO branding ring visible
  • P03 Shield valve mounted on a padded fabric panel, three-quarter angle showing zip trim and dump toggle
  • OPV P03 Shield in side profile, peaked tented lid linked by a corrugated hose to the connector
  • OPV P03 Shield front view of the domed lid face with hose routed to the connector
  • Exploded view of the P03 Shield valve: lid, coil spring, seat and diaphragm in sequence
  • P03 Shield valve close-up on a quilted fabric panel, Powered by HYDPRO branding ring visible
  • P03 Shield valve mounted on a padded fabric panel, three-quarter angle showing zip trim and dump toggle

OPV P03 Series

Ultra-flat profile with Shield Technology for debris protection.

OPV P03 Shield: 450 l/m exhaust, Core-Sink ultra-flat interface, Shield debris protection, conic coil spring

Specifications

Ultra-flat profile. Shielded against debris exposure

The P03 Series in Shield configuration extends the ultra-flat relief platform for buoyancy and inflatable systems built around the P03 interface. Shield Technology adds passive debris protection where external contamination exposure is more demanding. A protected ultra-flat relief platform shaped for streamlined integration and reduced snag exposure.

 Full technical specs (PDF)

Interface architecture. Defined by Series.

Each OPV Series is engineered around a dedicated flange geometry, defining fit, sealing and retention at the buoyancy-device boundary. Lid design and valve configuration vary within the Series; compatibility follows the interface geometry.

Built to integrate. True to your setup.

Whatever the field runs, HYDPRO builds to it natively: every established mount standard, thread, and host geometry, covered from the factory. Your setup stays as it is, integration stays clean, and the response repeats: the same command, the same result, on every dive.

Italian engineering. Predictable control

Each HYDPRO device is engineered and manufactured in Italy: one chain from raw material to release. Polymer families are selected for constant immersion, precision-drawn brass runs on in-house CNC lines, and every device leaves built, tested, and signed off under one roof.
HYDPRO power unit manufacturing: CNC machining, hand assembly, and the finished valve underwater

Proven by divers.
Refined by decades.

Four decades in the water stand behind the current generation. What wears, what binds, what drifts out of tune comes back from real dives to the bench, and the next revision answers it. Control you can feel, refined one generation at a time.

Featured Products

View all

OPV P01 Shield

OPV P01 Shield

Standard-profile with Shield Technology for debris protection.

Shield Range